Linksys router ea6400 no internet access

2 comments

• IF YOUR LINKSYS EA6400 IS NOT WORKING YOU CAN RESET YOUR DEVICE AND RE SETUP IT.
  TO SET UP YOUR LINKSYS ROUTER YOU NEED TO FOLLOW THESE STEPS:
  1. PLUG IN YOUR ROUTER TO A WALL SOCKET.
  2. CONNECT AN ETHERNET CABLE FROM YOUR MODEM TO INTERNET PORT OF YOUR ROUTER.
  3. CONNECT ANOTHER ETHERNET CABLE FROM PORT NO-4 OF YOUR ROUTER TO YOUR COMPUTER.
  4. OPEN RUN WINDOW AND TYPE CMD FOR ACCESSING LINKSYS ROUTER WRT54G V8.2.
  5. THEN ON CMD WINDOW TYPE IPCONFIG IT WILL SHOW YOU NETWORK STATISTICS.
  6. THEN OPEN A BROWSER AND TYPE DEFAULT GATEWAY IN ADDRESS BAR HIT ENTERS.
  7. WHEN YOU WILL HIT ENTER KEY THERE WILL BE A PROMPT ASKING USERNAME AND PASSWORD.
  8. DEFAULT USERNAME-admin PASSWORD-password.
  9. IT WILL OPEN A SETUP WIZARD YOU JUST NEED TO FOLLOW STEPS AND LINKSYS E1200 ROUTER WILL BE CONNECTED TO NETWORK.
  IF STILL PROBLEM PERSISTS YOU CAN RESET YOUR DEVICE.
  FEEL FREE TO CALL US BACK ON 1-800-603-4024.

  Reply

• You need to setup the router again ,Follow these steps –

  1.Check the attachment first so you can simply connect your router easily.
  2.Before setting the router you need to reset the router.
  -Just plug the power in the router .Only power .
  -Linksys do have reset button otherwise use reset pinhole.
  -Use paperclip and hold pinhole button or the reset button for 30 seconds then release it.
  -Wait for the power light to get solid.
  -Simply connect the ethernet cable and get the connection.
  3.Once you are connected open your browser and type in http://linksyssmartwifi.com or 192.168.1.1 .
  4.Setup wizard will appear .
  5.Follow the steps on the screen and configure the router .
  6.Once setup is done remove the ethernet cable from the computer.

  Reply