0
Mark Ludwig
New router, new ISPs. Need to reconfigure extender re450
0 Subscribers
Submit Answer
0 Answers
TO CONNECT YOUR TP LINK RE 450 EXTENDER YOU NEED TO FOLLOW THESE STEPS
1. CONNECT YOUR EXTENDER IN A DIRECT WALL SOCKET.
2. PRESS WPS BUTTON ON YOUR EXTENDER FOR 3-5 SECONDS.
3.PRESS WPS BUTTON ON YOUR ROUTER (YOU CAN DO IT BY ACCESSING ROUTER MAIN PAGE ALSO).
4.IT WILL BE CONNECTED TO YOUR ROUTERS NETWORK.
5.YOU WILL SE YOUR NETWORK NAME WITH EXT AFFIXED IN IT.
6.CONNECT TO THE SAME NETWORK .
7. IT WILL OPEN A SETUP WIZARD FOR YOU.
8.FOLLOW THE STEPS OF WIZARD AND YOU ARE GOOD TO GO NOW.
(IF PROBLEM STILL PERSISTS YOU CAN RESET YOUR DEVICE.)
FOR ANY QUESTION & QUERY FEEL FREE TO CALL US ON 1-800-603-4024.
TPlink-RE450 extender Setup –
Plug your extender into power socket . Avoid surge protector /Extensions !
You need to reset the extender so hold the reset button on extender for 25 seconds and release it.
1-Connect your device to extender’s network .
2-Open your Browser.
3-Type http://tplinkrepeater.net or 192.168.0.250 / 192.168.0.254 in address bar.
4-You need to login now with default login:-Username-admin /Password-admin.
5-Setup wizard will guide you through setup.
Setting up tp-link extender is really easy using WPS button. Here are the steps you will need to follow,
•First you will need to place the tp-link extender near to your router and then plug the power to WiFi extender.
•Press the WPS button located at the tp-link extender and do the same on your router, within two minutes, tp-link extender will connect itself with the existing network.
•Type http://tplinkrepeater.net or 192.168.0.250 in address bar ,if the setup is not working.
•You will notice that the LED status will be solid green.
Once your tp-link extender is connected with the existing network you can place the WiFi extender where the dead zones are at your location.
In order to configure the range extender you need to follow the instructions below:
> plug in your extender near to the router for the initial setup within 10 feets
> Press the WPS button on the router for 3 -4 seconds and then on the Extender for 3- 4 Seconds
> Once you see the light stopped flashing on the extender it means the extender is setup now
Step 2
> Connect your computer wireless to the extended network
> pull up browser and at the very top type in 192.168.0.254 or 192.168.1.254
> You will get through a login window default username: admin and the Password : admin
> click on quick setup and Continue , Follow the instructions to complete the setup