Leave a reply

4 comments
  • IF YOUR NETGEAR R700 IS NOT WORKING YOU CAN RESET YOUR DEVICE AND RESET UP THE DEVICE & TO SET UP YOUR ROUTER You need to plug in a cable from your existing modem to internet port of your router.
    after connecting this cable connect a cable from port no-4 of your router to your computer. then follow these steps:
    1. Press windows + R key that will open run window for you.
    2. Type CMD in the run box.
    3. Open Ipconfig and check network statistics.
    4. Open your default gateway in any browser.
    5. Type your user name and password .
    6.that will open a setup wizard for you so follow the steps and you are good to go.
    FOR ANY HELP FEEL FREE TO CALL US ON 1-800-603-4024.

  • NETGEAR NightHawk R7000 setup –
    1.Plug your router into power socket .
    2.Connect a Ethernet cable from modem to your router’s WAN port.
    3.Connect another cable from router to computer .
    4.Now open your browser and type in the address bar http://routerlogin.net / 192.168.1.1
    5.Select ‘Help me Choose’ and follow the instructions on the screen.
    6.Once your setup is completed remove the ethernet from computer.

  • There are different ways to access Netgear router login page. Routerlogin.net is the web address you can use to access login page.
    If you are facing issues accessing the Netgear router login page using routerlogin.net or routerlogin.com address, you can use the default IP address your router is using. You can locate the Netgear router login IP address using the command prompt.
    Just open the command prompt and type ipconfig. Press enter and from here you can find the login IP address for Netgear router login page. Login to the router with default cedentials and set up the internet connection.If you still can’t find the solution, better to talk to router login support team for help.

  • Make sure the cable connections are fine,if still you are facing issues please reset the router and set it up again using the following guide-

    1.Connect a Ethernet cable from modem to your router’s WAN port.
    2.Connect another cable from router to computer .
    3.Now open your browser and type in the address bar http://routerlogin.net .
    4.Select ‘Help me Choose’ and follow the instructions on the screen.
    5.Once your setup is completed remove the ethernet from computer.

Written by sumptgar15
Router Categories