0
RichN70
How to setup my netgear ex6120 Â extender?
0 Subscribers
Submit Answer
2 Answers
Best Answer
0
- Turn On your Netgear extender
- connect your computer with the extender's network
- open your browser and type this address:- 192.168.1.250
- It will take you to the setup page
- create an account for the Netgear extender
- After that it will search for the available wifi networks, select the network that you want to extend
- then enter the wifi password
- on the next page, create the wifi information for the extender
- save the settings
Replying as
Submit
Best Answer
0
plugin the extender into the wall socket near to your router for the initial setup
now connect any wireless device like computer, laptop or smartphone with the extender network and open the browser on the device and then in the long address type the IP address
it will take you to the setup wizard page, follow the instructions over there and then complete the setup process.
Replying as
Submit
TO CONNECT YOUR NETGEAR EX 6120 EXTENDER YOU NEED TO FOLLOW THESE STEPS
1. CONNECT YOUR EXTENDER IN A DIRECT WALL SOCKET.
2. PRESS WPS BUTTON ON YOUR EXTENDER FOR 3-5 SECONDS.
3.PRESS WPS BUTTON ON YOUR ROUTER (YOU CAN DO IT BY ACCESSING ROUTER MAIN PAGE ALSO).
4.IT WILL BE CONNECTED TO YOUR ROUTERS NETWORK.
5.YOU WILL SE YOUR NETWORK NAME WITH EXT AFFIXED IN IT.
6.CONNECT TO THE SAME NETWORK .
YOU ARE GOOD TO GO NOW.
(IF PROBLEM STILL PERSISTS YOU CAN RESET YOUR DEVICE.)
FOR ANY QUESTION & QUERY FEEL FREE TO CALL US ON 1-800-603-4024.
Setting your Netgear EX6120 Range extender.
1.Plug your extender in the wall .
2.Connect a Ethernet cable from extender to your computer.
3.Once your connected open your browser and type 192.168.1.250 / 192.168.1.254 .
4.Setup wizard will appear .
5.Create an account first.
6.Select range extender as your mode .
7.Follow the steps to complete the setup.
8.When setup is complete simply disconnect the ethernet cable from extender and computer .
•First you will need to place the Netgear extender near to your router and then plug in the power to WiFi extender.
•Press the WPS button located at the Netgear extender and press the wps setup on your router , within two minutes netgear extender will connect itself with the existing network.
•You will notice that the LED status will be solid green.
Once your Netgear extender is connected with the existing network you can place the WiFi extender where the dead zones are at your location.