Leave a reply

3 comments
  • TO SET UP YOUR LINKSYS AC1900 ROUTER YOU NEED TO FOLLOW THESE STEPS:
    1. PLUG IN YOUR ROUTER TO A WALL SOCKET.
    2. CONNECT AN ETHERNET CABLE FROM YOUR MODEM TO INTERNET PORT OF YOUR ROUTER.
    3. CONNECT ANOTHER ETHERNET CABLE FROM PORT NO-4 OF YOUR ROUTER TO YOUR COMPUTER.
    4. OPEN RUN WINDOW AND TYPE CMD FOR ACCESSING LINKSYS ROUTER WRT54G V8.2.
    5. THEN ON CMD WINDOW TYPE IPCONFIG IT WILL SHOW YOU NETWORK STATISTICS.
    6. THEN OPEN A BROWSER AND TYPE DEFAULT GATEWAY IN ADDRESS BAR HIT ENTERS.
    7. WHEN YOU WILL HIT ENTER KEY THERE WILL BE A PROMPT ASKING USERNAME AND PASSWORD.
    8. DEFAULT USERNAME-admin PASSWORD-password.
    9. IT WILL OPEN A SETUP WIZARD YOU JUST NEED TO FOLLOW STEPS AND LINKSYS E1200 ROUTER WILL BE CONNECTED TO NETWORK.
    IF STILL PROBLEM PERSISTS YOU CAN RESET YOUR DEVICE.
    FEEL FREE TO CALL US BACK ON 1-800-603-4024.

  • Check the attachment for cable connection with router and modem-

    1.Once you connect your router and modem open your browser.
    2.In browser type http://linksyssmartwifi.com or 192.168.1.1 .
    3.Setup wizard will appear just follow the steps.
    4.Once setup is completed you can remove the Ethernet cable from computer.

  • 1.PLUG IN THE ROUTER TO THE POWER.
    2.Connect an Ethernet cable from modem to your router’s WAN port.
    3.Connect another cable from router to computer .
    4.Now open your browser and type in the address bar http://linksyssmartwifi.com .
    5.follow the instructions on the screen.
    6.Once your setup is completed remove the ethernet from computer.

Written by jandlstraub
Router Categories