Leave a reply

2 comments
  • Belkin extenders are plug & play devices, you just need to connect to it setup page pops up by itself whenever you open any web browser
    if its not doing this way
    > Make sure its plugged in properly.
    > When it shows blue or amber light that means it is ready to configure.
    > Make sure it is showing on your WiFi list there.
    > Connect to it.
    > Once connected go to any web browser and type in there the IP of your extender IP = 192.168.206.1 (which will take you to the setup page).
    > Now you just need to follow simple guided steps there.
    > Then you are good to go.



    0



  • > Turn On your Belkin Extender
    > Connect your Computer or Smartphone with the Extender's Network
    > Open your Web Browser and Type this Address:- 192.168.206.1
    > Now it will Scan for available wifi networks
    > Select your network that you want to extend
    > Enter the Same wifi password that you were using for your existing network
    > Then it will show you Extended Network name and password and if you want to change that name ,you can click on Edit option and rename it and once you change the name click on save.
    > Now it will save the settings, and once the setting is saved it means Extender is configured
    > You can connect your wireless devices with the Extender's network.
    or
    We can also configure it through Wps option and for that
    press and hold the wps button from your extender for at least 3 seconds and with in 2 minutes press and hold the wps button from your main router for at least 3 seconds.
    And then wait for the extender to reboot itself.
    (But make sure that your Extender is within 10 Ft. from your main router)



    0



Written by Joe Katona
Router Categories