Leave a reply

4 comments
  • Plug the Belkin range extender into a power outlet that’s within the full-strength signal of your home’s Wi-Fi network.
    Use your mobile device or computer to browse the available networks and select Belkin.setup from the list.
    Launch your Web browser and navigate to http://Belkin.range.
    Click Get Started on Belkin’s setup



    0



  • For new Belkin Extender.
    Just press the WPS on your router/modem first for 1-2 seconds, then press the WPS on Belkin Extender for 3-5 seconds.
    Now wait for 2 minutes.
    The difference in light color and pattern will confirm its connection.

    For Used/ old Belkin Extender: If its an used extender then first reset it using a paper clip to press the reset button in a tiny hole for 30 seconds.
    Now its brand new, or by default one.
    Wait for 2 minutes after reset then proceed further as setup New Belkin Extender.

    Its now extending your home network with same password as of your home wifi.

    Note:
    1. During setup, make sure that the Belkin Extender is placed within 7-10 feet from Router, at the time of setup, or in the same room.
    2. Two minutes patience is the Critical Time that make the difference between success and failure in Setup.



    0



  • first check the wifi list, you will see the belkin.setup name in the list, connect with it. Now open the browser and type belkin.range, you will se the belkin login dashboard. if still not getting you can reset your extender and type again belkin.range it will work and reconfigure your extender again with the router.



    0



Written by Carolyn Rivera
Router Categories