Leave a reply

3 comments
  • All of Belkin’s Wi-Fi extenders also support wireless Web setup. In addition to your router and extender, you’ll also need a Web-enabled device — like a laptop or tablet — with Web browsing capabilities.

    Plug the Belkin range extender into a power outlet that’s within the full-strength signal of your home’s Wi-Fi network.
    Use your mobile device or computer to browse the available networks and select Belkin.setup from the list.
    Launch your Web browser and navigate to http://Belkin.range.
    Click Get Started on Belkin’s setup Web page and then select your at&t home’s Wi-Fi name from the list of available networks.
    Enter your Wi-Fi network’s password when prompted and select Next.
    Select your Wi-Fi network once again, click Next, and then click Create Extended Network.

  • For new Belkin Extender.
    Just press the WPS on your router/modem first for 1-2 seconds, then press the WPS on Belkin Extender for 3-5 seconds.
    Now wait for 2 minutes.
    The difference in light color and pattern will confirm its connection.

    For Used/ old Belkin Extender: If its an used Belkin Extender then first reset it using a paper clip to press the reset button in a tiny hole for 30 seconds.
    Now its brand new, or by default one.
    Wait for 2 minutes after reset then proceed further as setup New Belkin Extender.

    Its now extending your home network with same password as of your home wifi.

    Note:
    1. During setup, make sure that the Belkin Extender is placed within 7-10 feet from Router, at the time of setup, or in the same room.
    2. Two minutes patience is the Critical Time that make the difference between success and failure in Setup.

  • First connect your belkin extender 2-3 feet away from your router and press WPS push button on your extender first and after on you router now both devices will be coonect with each other, Now open the wifi list in your computer and connect with belkin.setup, and after open the browser and type belkin.range extender setup page will be open now go with the step and complete the setup, after the complete setup now you can connect this extender 25-30 feet away from the router and it will extend the wifi in dead zone area.

Written by Carolyn Rivera
Router Categories