Leave a reply

2 comments
  • If your router/gateway supports WPS, press the WPS button on your router/gateway for 5 seconds until the WPS indicator lights/blinks to initiate the connection.
    Within 60 seconds, press and hold the WPS button on your extender for 5 seconds.
    Wait for up to 5 minutes until the WPS indicator stop blinking.
    Check if the router link LED on your extender is ON or OFF.
    If the link LED is ON, your extender successfully connected to your router’s Wi-Fi network.
    If the link LED is OFF, the extender failed to connect to the router Wi-Fi network, please repeat steps 1-3 to try again.
    If your extender and router are dual band devices, repeat steps 1-4 to configure the 5GHz network.
    Move your extender to its preferred location which is ideally halfway between your router and the area with poor Wi-Fi signal.

  • To setup Tplink RE210 range extender with Comcast router follow these steps:-
    >Plugin the range extender into the wall socket near to your Comcast router for the initial setup.
    *If you made any change on the extender before, then reset the extender by pressing reset button for at least 30 seconds.
    >Connect any of your wireless device with Tplink extender’s wireless network.
    >Open any browser and in the address bar type 192.168.1.254 or 192.168.0.254 or http://tplinkrepeater.net
    >Now you will see the setup wizard in the page, follow the instructions to setup the range extender
    >If you want you can change the name of extended network and password of your choice that you want for it.
    >Now save the settings and range extender will reboot after saving the settings.
    >Once extender lights get solid connect your devices to the extended network and try to go online so that we can check that extender setup done successfully.

Written by carolyn deal
Router Categories