0
Nicole Macurak
How do i connect my re6700 extender?
0 Subscribers
Submit Answer
0 Answers
For new re6700 Extender.
Just press the WPS on your router/modem first for 1-2 seconds, then press the WPS on re6700 Extender for 3-5 seconds.
Now wait for 2 minutes.
The difference in light color and pattern will confirm its connection.
For Used/ Old re6700 Extender: If its an used re6700 Extender then first reset it using a paper clip to press the reset button in a tiny hole for 30 seconds.
Wait for 2 minutes after reset then proceed further as setup new re6700 Extender.
Its now extending your home network with same password as of your home wifi.
Note:
1. During setup, make sure that the re6700 Extender is placed within 7-10 feet from Router, at the time of setup, or in the same room.
2. Two minutes patience is the Critical Time that make the difference between success and failure in Setup.
#To setup your re6700 extender kindly follow these steps:-
-Plug in your extender in to the wall socket
-Press the reset button/Pin hole on your extender for 10 seconds .
-Wait Till the time all lights on you extender are back again.
-Now you can connect your computer with the extended network.
-Once connected with network open the Default IP of your extender i.e
-Now follow the steps and set up your extender with the existing network
-Once configured You can took your extender to the place where you would like to use it
-Connect your devices with the extended network .