0
Anthony John
0 Subscribers
Submit Answer
0 Answers
To setup Tplink RE200 range extender follow these steps:-
>Plugin the range extender into the wall socket near to your home router for the initial setup.
*If you made any change on the extender before, then reset the extender by pressing reset button for at least 30 seconds.
>Connect any of your wireless device with tplink extender wireless network.
>Open any browser and in the address bar type 192.168.1.254 or 192.168.0.254 or http://tplinkrepeater.net
>Now you will see the setup wizard in the page, follow the instructions to setup the range extender
>If you want you can change the name of extended network and password of your choice that you want for it.
>Now save the settings and range extender will reboot after saving the settings.
>Once extender lights get solid connect your devices to the extended network and try to go online so that we can check that extender setup done successfully.
#To setup your Tp-link re200 extender kindly follow these steps:-
-Plug in your extender in to the wall socket
-Press the reset button/Pin hole on your extender for 10 seconds .
-Wait Till the time all lights on you extender are back again.
-Now you can connect your computer with the extended network.
-Once connected with network open the Default IP of your extender i.e 192.168.1.254
-Now follow the steps and set up your extender with the existing network
-Once configured You can took your extender to the place where you would like to use it
-Connect your devices with the extended network .
In order to re-setup an extender, please follow the steps below:
Reset the extender, Press and hold the reset button down for 30 seconds and then wait for at least 1 minute.
In order to configure the range extender you need to follow the instructions below:
> plug in your extender near to the router for the initial setup within 10 feets
> Press the WPS button on the router for 3 -4 seconds and then on the Extender for 3- 4 Seconds
> Once you see the light stopped flashing on the extender it means the extender is set up now
Step 2
> Connect your computer wireless to the extended network
> pull up a browser and at the very top type in 192.168.0.254 or 192.168.1.254
> You will get through a login window default username: admin and the Password: admin
> click on quick setup and Continue , Follow the instructions to complete the setup