0
Roy Leddy
How do i connect my tplink TL-WR841N router with my old devices?
0 Subscribers
Submit Answer
0 Answers
For new tplink TL-WR841N.
Just press the WPS on your router/modem first for 1-2 seconds, then press the WPS on tplink TL-WR841N for 3-5 seconds.
Now wait for 2 minutes.
The difference in light color and pattern will confirm its connection.
For Used/ Old tplink TL-WR841N: If its an used tplink TL-WR841N then first reset it using a paper clip to press the reset button in a tiny hole for 30 seconds.
Now its brand new, or by default one.
Wait for 2 minutes after reset then proceed further as setup New tplink TL-WR841N.
Its now extending your home network with same password as of your home wifi.
Note:
1. During setup, make sure that the tplink TL-WR841N is placed within 7-10 feet from Router, at the time of setup, or in the same room.
2. Two minutes patience is the Critical Time that make the difference between success and failure in Setup.
#To setup your tplink TL-WR841N kindly follow these steps:-
_-Plug in your extender in to the wall socket
-Just press the wPS button on your router or reset button then press the wps button on the tplink TL-WR841N.
-Press the reset button/Pin hole on your extender for 10 seconds .
-Wait Till the time all lights on you extender are back again.
-Now you can connect your computer with the extended network.
-Once connected with network open the Default IP of your extender i.e 192.168.0.254
-Now follow the steps and set up your extender with the existing network
-Once configured You can took your extender to the place where you would like to use it
-Connect your devices with the extended network .
In order to setup your tplink router follow the steps given below:
> Connect a cable from your modem’s LAN port to the internet port of the router
> Connect your computer wireless to the routers default SSID or via Ethernet cable
> Pull up a browser and at the top on the address bar type in 192.168.0.1 and hit enter
> you will come through your router login screen default username : admin and Password : admin
> setup page will come up , Follow the instruction to complete the setup
Note : It should be Dynamic Ip and do not clone the MAC of the computer.