I changed my modem , now my extender is not working .How to fix this?(linksys re6300 )

2 comments

• In Case you Changed Modem/Router, your home Wifi Name will also change which is your new SSID of new router.
  Now you need to reset the Linksys RE6300 Extender, in order to setup.
  How to reset Device Linksys RE6300, it will be done by pressing the reset button inside a tiny hole on the back of the Linksys RE6300 Extender, using a paper clip for 30 seconds, while its plugged in to the wall.
  Wait for 2-3 minutes after reset and go to setup Linksys RE6300 Extender page to set it up again.

  Now select the Linksys default name from your computer and visit 192.168.0.1 and follow the steps to setup your Linksys RE6300 Extender.

  If need technical help, call 1800 810 8012

  
  
  

  0

  
  
  

  Reply

• In order to run Linksys Re6300 with the new modem Please follow the steps below:
  > you would need to first reset the Extender by pressing the reset button down for 30 seconds
  > Once you see an orange flashing light on the extender the follow the instruction below
  Step 1
  > First connect your computer wireless or wired to the range extender
  > login to extender.linksys.com or go to 192.168.1.1
  > initiate the setup.
  Step 2
  > Press the WPS button on the router first for 3 seconds and then on the extender for 3 seconds once the light on the extender stops blinking the setup is complete.

  
  
  

  0

  
  
  

  Reply