BELKIN EXT

3 comments

• How to setup a Belkin F9k1015v1 Extender ?

  For new Belkin F9k1015v1 Extender.
  Just press the WPS on your router/modem first for 1-2 seconds, then press the WPS on Belkin F9k1015v1 Extender for 3-5 seconds.
  Now wait for 2 minutes.
  The difference in light color and pattern will confirm its connection.

  For Used/ old Belkin F9k1015v1 Extender : If its an used Belkin F9k1015v1 Extender then first reset it using a paper clip to press the reset button in a tiny hole for 30 seconds.
  Now its brand new, or by default one.
  Wait for 2 minutes after reset then proceed further as setup New Belkin F9k1015v1 Extender.

  Its now extending your home network with same password as of your home wifi.

  Note:
  1. During setup, make sure that the Belkin F9k1015v1 Extender is placed within 7-10 feet from Router, at the time of setup, or in the same room.
  2. Two minutes patience is the Critical Time that make the difference between success and failure in Setup.
  3. Best of luck

  
  
  

  0

  
  
  

  Reply

• For the wired connection just plug the ethernet cable in the router and other end in the extender.
  On your computer open up a web browser and type the website belkin.range to get the startup page
  You will see the option of GET STARTED click on it and you will see the network list
  Just select your network name and enter the wifi password
  Just Follow the steps and it will be connected.

  For the wireless connection the steps are the same as for wired
  It is just that you need not to plug the ethernet wire and place the extender near to the router about 10 feet.

  Thank You

  
  
  

  0

  
  
  

  Reply

• In order to configure the Belkin range extender you need to follow the instructions below:
  > plug in your extender near to the router for the initial setup at least 10 feets
  > Press the WPS button on the router for 3 -4 seconds and then on the Extender for 3- 4 Seconds
  > Once you see the light stops flashing on the extender it means the extender is set up now
  Step 2
  > Connect your computer wireless to the extended network
  > pull up a browser and at the very top type in 192.168.206.1
  > You will get through the setup wizard for your Belkin Extender
  > click on get started and run the setup , Follow the instructions to complete the setup

  
  
  

  0

  
  
  

  Reply