0
Janell Unruh
0 Subscribers
Submit Answer
0 Answers
For new Linksys Extender.
Just press the WPS on your router/modem first for 1-2 seconds, then press the WPS on Linksys Extender for 3-5 seconds.
Now wait for 2 minutes.
The difference in light color and pattern will confirm its connection.
For Used/ old Extender: If its an used Linksys Extender then first reset it using a paper clip to press the reset button in a tiny hole for 30 seconds.
Now its brand new, or by default one.
Wait for 2 minutes after reset then proceed further as setup New Linksys Extender.
Its now extending your home network with same password as of your home wifi.
Note:
1. During setup, make sure that the extender is placed within 7-10 feet from Router, at the time of setup, or in the same room.
2. Two minutes patience is the Critical Time that make the difference between success and failure in Setup.
3. Best of luck
In order to setup your Linksys router follow the steps given below:
> Connect a cable from your modem’s LAN port to the internet port of the router
> Connect your computer wireless to the routers default SSID or via Ethernet cable
> Pull up a browser and at the top on the address bar type in 192.168.1.1 or https://www.linksyssmartwifi.com and hit enter
> you will come through your router login screen default username: admin and Password: admin
> setup page will come up, Follow the instruction to complete the setup
========================================================================================
In order to setup theLinksys Range extender you would need to follow the following steps:
Step 1
> First connect your computer wireless or wired to the range extender
> logon to extender.linksys.com or 192.168.1.1
> initiate the setup.
Step 2
> Press the WPS button on the router first for 3 seconds and then on the extender for 3 seconds once the light on the extender stops blinking the setup is complete.