0
tommy stewart
how to setup a Tplink Router AC1600 as an AP?
0 Subscribers
Submit Answer
0 Answers
To configure Tp-link AC1600 router as an access point you need to follow these steps:-
> You need to plug in a cable from your existing Router to internet port of your router.
> After connecting the cable connect a cable from port no-4 of your router to your computer. then follow these steps:
> Open your browser and at the very top on the address bar type in 192.168.0.1 and hit enter.
> the default password is: admin
> that will open a setup wizard for you so follow the steps and complete the setup
> while following the setup wizard kindly make sure the settings you are choosing is correct i.e time zone and wireless network name and wireless password
> kindly upgrade the router firmware as well if there is an update pending.
>Now once the setup is done go to the Advance settings and click on Network
> Change the default Ip from 192.168.0.1 to 192.168.50.1
> save the new Ip address and wait until it connects you back to the router settings
> once connected back go to the Advance settings and then networks.
> under network disable the DHCP configuration and save it.
> once it is done unplug the ethernet cable from the computer and the Tp-link Router
> The cable that was connected to the internet port of your Tp-link router from your Existing Router you disconnect it from there and plug it into port number 1, 2, 3, 4 any one of these.
Reboot the existing router and the Tp-Link it will start working as an access point.