LINKSYS

2 comments

• Well in this case you need to take a paper clip and insert into the reset pin hole of your extender and hold it down for 20-30 seconds.
  Then unplug your extender from the socket while holding the clip in.
  Remove the clip out and plug in your extender again and your extender will be reseted and you will see the the name of your extender there .

  
  
  

  0

  
  
  

  Reply

• If you are not able to reset the extender , Follow the steps below:
  > Make sure the extender should be ON
  > Press and hold the reset pin hole down with a paper clip for 30 seconds
  > While holding it down unplug the extender from the power and wait for 30 seconds
  > Put the extender back to wall and wait for 30 seconds and then release the Reset button
  > then wait for at least 2 minutes and the extender will be reset.

  
  
  

  0

  
  
  

  Reply