Leave a reply

2 comments
  • As you have mentioned that your extender is not working from last night kindly check signal strength from your router,also check whether it is properly plugged in or not.if problem still persists kindly change the location of your extender.
    at last kindly reset your extender with the help of a paper clip and re setup your device.
    To Re setup the device kindly follow these steps:-
    1.Plug your Range Extender into a power outlet near your main Router.
    2.Push the WPS button on your main Router first, then immediately push the WPS button on your Range Extender.
    3. After you have pushed WPS button of your Router, you need to push WPS button of your Range Extender within 2 minutes. .
    4.After pushing the WPS button of your Router, your Router WPS LED should blink. If your Router WPS LED doesn’t blink, it means you need to push the WPS button again until the WPS LED of your Router blinks. The same reason is also suitable for RE product. After pushing the WPS button of your Range Extender, the WPS light of your Range Extender should blink. If not, push again.
    5.The WPS process will last 2 minutes. You can wait 2 minutes, and then check the wireless signal LED of your Range Extender.
    5. After 2 minutes, if the wireless signal LED of your Range Extender is still off, it means the WPS process fails. You may need to try one more or several more times of WPS operation, and repeat the steps above.
    6. At last, you can put your Range Extender in a proper place where you want to extend the wireless network’s coverage, and enjoy the extended wireless network. No need to repeat the process. Once it’s done, it will connect automatically every time you plug it back in.
    For any help feel free to call us back on 1-800-603-4024.



    0



  • In order to get your Range extender back to work please follow the instruction Below:
    > Plug in your extender near to your router maybe by 5 -10 feets
    > Reset the extender by pressing the reset button on the extender for 25-30 seconds
    > wait for the extender complete the reset process and then follow the steps below to re-setup the extender.

    Step 1
    > First connect your computer wireless or wired to the range extender
    > logon to extender.linksys.com
    > initiate the setup.
    Step 2
    > Press the WPS button on the router first for 3 seconds and then on the extender for 3 seconds once the light on the extender stops blinking the setup is complete.



    0



Written by jIMMY d
Router Categories