Leave a reply

3 comments
  • Follow these steps-
    >Plugin range extender into the wall socket nearby to your home router for the initial setup.
    >Once the extender lights get stable/solid press the WPS button and hold it down for 5 seconds.
    >Within 2 minutes press the WPS button on your home router.
    >Wait for the extender lights get stable and now try to connect any of your wireless devices with extender network.
    *If you want to connect your range extender with 5Ghz network then repeat the same step once again.



    0



  • 1.CONNECT YOUR EXTENDER IN A DIRECT WALL SOCKET.
    2. PRESS WPS BUTTON ON YOUR EXTENDER FOR 3-5 SECONDS.
    3.PRESS WPS BUTTON ON YOUR ROUTER AND YOU WILL SEE LIGHTS STARTS BLINKING ON YOUR EXTENDER.
    4.IT WILL BE CONNECTED TO YOUR ROUTERS NETWORK ONCE THE LIGHT WILL BE SOLID.
    5.NOW ENTER THE ADDRESS FOR YOUR EXTENDER SET UP.
    6.LOGIN WITH DEFAULT CREDENTIALS THERE.
    7. IT WILL OPEN A SETUP WIZARD FOR YOU.
    8.FOLLOW THE STEPS OF WIZARD AND YOU ARE GOOD TO GO NOW.



    0



  • In order to configure the range extender you need to follow the instructions below:
    > plug in your extender near to the router for the initial setup within 10 feets
    > Press the WPS button on the router for 3 -4 seconds and then on the Extender for 3- 4 Seconds
    > Once you see the light stopped flashing on the extender it means the extender is setup now



    0



Written by Nadhem Mikhail
Router Categories