Leave a reply

3 comments
  • TO CONNECT YOUR NETGEAR EXTENDER FROM TP LINK ROUTER YOU NEED TO FOLLOW THESE STEPS
    1. CONNECT YOUR EXTENDER IN A DIRECT WALL SOCKET.
    2. PRESS WPS BUTTON ON YOUR EXTENDER FOR 3-5 SECONDS.
    3.PRESS WPS BUTTON ON YOUR TP LINK ROUTER (YOU CAN DO IT BY ACCESSING ROUTER MAIN PAGE ALSO).
    4.IT WILL BE CONNECTED TO YOUR ROUTERS NETWORK.
    5.YOU WILL SE YOUR NETWORK NAME WITH EXT AFFIXED IN IT.
    6.CONNECT TO THE SAME NETWORK .
    7. IT WILL OPEN A SETUP WIZARD FOR YOU.
    8.FOLLOW THE STEPS OF WIZARD AND MAKE THE NECESSARY CHANGES ACCORDING TO YOURSELF.
    9.YOUR EXTENDER WILL REBOOT THEN YOU ARE GOOD TO GO NOW.

  • In order to setup your Netgear Range Extender Wn2500 RPT V2 you need to follow the instruction:
    Step 1
    > plug in the extender near to the extender for the initial setup
    > Press and hold the WPS button on the router for 3 seconds and then on the extender for 3 seconds
    > once you see the the light flashing on the extender is solid it means the setup is complete
    Step 2
    > Connect your computer wirelessly to teh extended network to the default name or SSID
    > Pull up a browser and at the very top type in 192.168.1.250 or http://mywifiext.net
    > you will come through a setup wizard follow the instruction and complete the setup

  • WPS method will work for you easily.
    Plug your extender near to your TP-Link router.
    If you have already tried setup before, reset the extender.
    Press Reset button for 10 seconds.
    Wait for 3 minutes.
    Now press WPS button on the router for 4 seconds.
    Press WPS on the extender for 4 seconds.
    Wait for 3-4 minutes.
    You can see the wireless name with _EXT and connect to it using your router password.
    If you didn’t get the internet you need to reset it again.
    Connect an ethernet cable from extender to your PC.
    Open https://192.168.1.250/254 or https://mywifiext.net to access the setup page.

Written by Joseph Scuba Dad
Router Categories