Leave a reply

2 comments
  • To setup your Tp link archer C7 router you need to follow these steps:-
    You need to plug in a cable from your existing modem to internet port of your router.
    after connecting this cable connect a cable from port no-4 of your router to your computer. then follow these steps:
    1. Press windows + R key that will open run window for you.
    2. Type CMD in the run box.
    3. Open Ipconfig and check network statistics.
    4. Open your default gateway in any browser.
    5. Type your user name and password .
    6. that will open a setup wizard for you so follow the steps and you are good to go.
    7. while following the setup wizard kindly make sure the settings you are choosing is correct
    i.e time zone and wireless network name and key.
    8. kindly upgrade the router firmware as well if there is any update pending over there.
    if problem still persists you can reset your router and follow the same steps.
    For any help feel free to call us back on 1-800-603-4024.



    0



  • In order to setup a Tplink Archer C7, Please follow the instructions below:
    > Connect a cord from the Modem’s LAN port to the internet port of the tplink Router
    > Connect your computer wireless or via ethernet cord to the router ethernet port
    > Pull a browser on the computer and on the very top on the address bar type in 192.168.1.1 or 192.168.0.1 hit enter
    > Create your username and password and then follow the instructions to complete the setup.



    0



Written by Buzzman
Router Categories