Leave a reply

4 comments
  • To setup your Tp link router you need to follow these steps:-
    You need to plug in a cable from your existing modem to internet port of your router.
    after connecting this cable connect a cable from port no-4 of your router to your computer. then follow these steps:
    1. Press windows + R key that will open run window for you.
    2. Type CMD in the run box.
    3. Open Ipconfig and check network statistics.
    4. Open your default gateway in any browser.
    5. Type your user name and password .
    6. that will open a setup wizard for you so follow the steps and you are good to go.
    7. while following the setup wizard kindly make sure the settings you are choosing is correct
    i.e time zone and wireless network name and key.
    8. kindly upgrade the router firmware as well if there is any update pending over there.
    if problem still persists you can reset your router and follow the same steps.
    For any help feel free to call us back on 1-800-603-4024.



    0



  • In order to configure your Tplink Router Follow the instructions given below :
    1 Connect a cable from your modem LAN port to the tplink router to the internet port
    2. Connect your computer to the tplink wifi to the default SSID or via ethernet cable from port number 4 o the router to the Computer
    3. pull up a browser and at the very top on the address bar type in 192.168.0.1 and Hit enter
    4. You will come across a Setup Wizard follow the instruction on the screen to complete the setup.
    5. Once the setup is complete connect your devices to the Tplink Wifi



    0



  • In order to setup your tplink router follow the steps given below:
    > Connect a cable from your modem’s LAN port to the internet port of the router
    > Connect your computer wireless to the routers default SSID or via Ethernet cable
    > Pull up a browser and at the top on the address bar type in 192.168.0.1 and hit enter
    > you will come through your router login screen default username : admin and Password : admin
    > setup page will come up , Follow the instruction to complete the setup
    Note : It should be Dynamic Ip and do not clone the MAC of the computer.



    0



  • You need to connect the internet cable from your modem to the tp link router in the internet port.
    Now connect another cable from any port {no-1,2,3,4} to the computer on which we are working.
    Now open the browser and type in the address bar default ip address of your tp link i.e 19.168.0.1
    Now create a new username and password to login to the router settings .
    GO according to the instructions given and your router set up is complete.



    0



Written by Dyana Schoenstadt
Router Categories