Leave a reply

4 comments
  • Please follow the following steps to configure the WNR2000v3 with your modem initial setup :
    > Connect a ethernet cable from the modems LAN port to the Routers Internet port
    > Connect your computer to the router wireless or via cable
    > pull up a browser and logon on to http://www.routerlogin.net or 192.168.1.1 and hit enter
    > You will see the setup wizard
    just follow the instruction and complete the initial setup setup

  • To setup your Netgear wnr2000v3 router you need to follow these steps:-
    You need to plug in a cable from your existing modem to internet port of your router.
    after connecting this cable connect a cable from port no-4 of your router to your computer. then follow these steps:
    1. Press windows + R key that will open run window for you.
    2. Type CMD in the run box.
    3. Open Ipconfig and check network statistics.
    4. Open your default gateway in any browser.
    5. Type your user name and password .
    6. that will open a setup wizard for you so follow the steps and you are good to go.
    7. while following the setup wizard kindly make sure the settings you are choosing is correct
    i.e time zone and wireless network name and key.
    8. kindly upgrade the router firmware as well if there is any update pending over there.
    if problem still persists you can reset your router and follow the same steps.
    For any help feel free to call us back on 1-800-603-4024.

  • Netgear products are plug ‘n’ play devices.
    Follow the steps provided to setup your Netgear wnr2000v3 –

    1. Plug in your router into a wall socket.
    2. Now connect an Ethernet cable from your Internet modem to the netgear router’s Internet yellow port.
    3. Now you need to connect your router to Your computer. You can use wireless connection or hardwired connection.
    4. Once you have the cable setup done, open your internet browser on your computer and type http://www.routerlogin.net
    5. You will see the setup wizard, so follow on screen steps to complete the setup.

  • CONNECT AN ETHERNET CABLE FROM THE MODEM TO ROUTER AND THEN ROUTER TO COMPUTER.
    NOW OPEN THE DEFAULT IP ADDRESS OF YOUR ROUTER I.E 192.168.1.1 OR http://WWW.ROUTERLOGIN.NET
    YOU WILL SEE THE NETGEAR GENIE PAGE HERE AND IT WILL DETECT THE INTERNET CONNECTION FROM MODEM TO THE ROUTER.
    GO ACCORDING TO THE INSTRUCTIONS AND COMPLETE THE SET UP .

Written by karin somerville
Router Categories