Leave a reply

4 comments
  • First you will need to place the tp-link extender near to your router and then plug the power to WiFi extender.
    Press the WPS button located at the tp-link extender and do the same on your router, within two minutes, tp-link extender will connect itself with the existing network.
    Type http://tplinkrepeater.net or 192.168.0.250 in address bar ,if the setup is not working.
    Once your tp-link extender is connected with the existing network you can see the light on it is solid green.
    Now you can place the WiFi extender at any place



    0



  • To setup your Tp link extender kindly follow these steps:-
    1.Plug your Range Extender into a power outlet near your main Router.
    2.Push the WPS button on your main Router first, then immediately push the WPS button on your Range Extender.
    3. After you have pushed WPS button of your Router, you need to push WPS button of your Range Extender within 2 minutes. .
    4.After pushing the WPS button of your Router, your Router WPS LED should blink. If your Router WPS LED doesn’t blink, it means you need to push the WPS button again until the WPS LED of your Router blinks. The same reason is also suitable for RE product. After pushing the WPS button of your Range Extender, the WPS light of your Range Extender should blink. If not, push again.
    5.The WPS process will last 2 minutes. You can wait 2 minutes, and then check the wireless signal LED of your Range Extender.
    5. After 2 minutes, if the wireless signal LED of your Range Extender is still off, it means the WPS process fails. You may need to try one more or several more times of WPS operation, and repeat the steps above.
    6. At last, you can put your Range Extender in a proper place where you want to extend the wireless network’s coverage, and enjoy the extended wireless network. No need to repeat the process. Once it’s done, it will connect automatically every time you plug it back in.
    For any help feel free to call us back on 1-800-603-4024.



    0



  • In order to do the setup for the extender you would first need to make sure the router is close to the extender at least 5 feets for the initial setup and after it you can take it to the other place.
    > Press the WPS button on the router first and then on the extender for 3-5 Seconds once the light goes solid.
    > Connect your computer to the wireless of the extender to the default SSID
    > logon to to either http://www.tplinkrepeater.net or 192.168.0.254
    > default password is : admin , Default username is: admin
    > initiate the setup process



    0



  • There are the following ways to set up the Tp-Link extender:
    First of all you need to plug in the Tp-Link extender near by your router atleast 4-5 feet and then you need to push the WPS button on the router for 2-3 seconds . Now you can see the WPS led will blink after that you need to push the WPS button on the extender and you can see the WPS led will blink on the extender as well, now you can connect the computer through wireless with Tp-link extender name showing on the wifi list now you need to go to the website http://www.tplinkrepeater.net or you can use the IP address 192.168.0.254 or 192.168.0.250 and you can see the set up page will appear up on the screen and asking for the username & password . The default username is admin and the password is also admin and then you need to follow the instructions, finally the extender set up will done. So you can place the Tp-link extender where you want to place in your home.



    0



Written by Anna Lam
Router Categories