Leave a reply

3 comments
  • This is a very good extender which you got and easy to set up
    With the extender powered on, use a pin to press and hold the Reset button
    until the RE590T logo displays.
    At first login, create a new administrator password (recommended) and tap Save.
    Select your region, then tap Next.
    Select your host router’s 2.4GHz wireless network and enter its password, then tap
    Next
    Select your host router’s 5GHz wireless network and enter its password, then tap
    Next.
    Either keep the default SSIDs or customize them for both 2.4GHz and 5GHz extended
    networks, then tap Next
    Verify your wireless settings and tap Finish. Corresponding Wi-Fi signal icon(s)(
    2.4GHz / 5GHz) at the top left of the touchscreen should be lit.
    After this you can relocate your extender and enjoy the internet



    0



  • Thanks for sharing your concern with us, we tried your number but it was on voicemail

    Before we proceed to setup the router we need to perform some steps given below:-

    : -Turn off the modem and remove battery if it has one.
    : -Connect the modem to the internet port on the router via an Ethernet Cable.
    : -Turn on the modem and wait about two minutes.
    :-Turn on the router and wait until the system boots on the screen completes.
    :-Configure the router on touchscreen display.
    -Create a new administrator password and tap save,then follow the Quick Setup to complete the initial configuration.
    Connect your devices to the router wirelessly or via an ethernet cable.

    If in case you still unable to setup the router please feel free to call us at 1-800-603-4024 and get additional help.



    0



  • kindly Follow these steps to connect your Touch P5.
    1. Install the antennas and position them vertically.
    2. Turn off the modem, and remove the backup battery if it has one.
    3. Connect the modem to the Internet port of your Touch P5 via an Ethernet cable.
    4. Turn on the modem, and wait 2 minutes for it to restart.
    5. Turn on your Touch P5 and wait until the system boot on the screen completes.
    6. Connect your computer to your Touch P5.
    7.Use the default SSID (Wireless Network Name) and Wireless Password printed on the product label at the bottom of your Touch P5 to connect wirelessly.
    You can log in and manage your Touch P5 through the touchscreen or web-based utility.
    1. Tap the home button or the screen and slide to start the screen.
    2. The first time you log in, you will need to set a new administrator password for your Touch P5. Enter the new password and enter again to confirm. Tap Save, then follow the Quick Setup to complete the initial configuration.
    For any help feel free to call us back on 1-800-603-4024.



    0



Written by Mary Bowman
Router Categories