How do I connect and configure my Linksys Router to use PPPoE DSL service?

2 comments

• Most DSL providers use Point-to-Point Protocol over Ethernet (PPPoE) to establish Internet connections for end-users. To set up Linksys EA 7300 router, you need to enable PPPoE on the router’s web-based setup page.
  1. first connect your computer directly to your modem and check are you getting internet. If not,
  contact your Internet Service Provider (ISP)
  2. now connect the modem to the router’s Internet port and the computer to any of the four
  Ethernet ports.
  3. After connecting your modem and PC to the router, check the lights on the front panel of the
  router.
  4. now open the router main page on your computer.
  5. now look for the Local IP Address and change it to 192.168.2.1 and save the settings.
  6. Renew the computer’s IP Address.
  7. Access the router’s web-based setup page using 192.168.2.1 as the IP Address.
  8. On the Setup page, click Status and check if Internet IP Address has numbers or values.
  9. Under the Setup tab, set the Internet Connection Type to PPPoE.
  10.Enter the Username and Password that your ISP provided, including the domain in the User
  Name field if necessary and save the settings.
  by following these steps you can setup your router easily.
  for any help feel free to call us back on 1-800-603-4024.

  
  
  

  0

  
  
  

  Reply

• 1. Connect your modem to the router and then router to the computer
  2. Open the router page on the computer in any browser
  3. Check the local IP and try changing it to 192.168.2.1 and rener computer’s IP as well
  4. Open 192.168.2.1 in any browser and will open router dashboard
  5. In setup option select internet connection type to PPPOE
  6. Put the credentials given by ISP and save the settings and you are good to go

  
  
  

  0

  
  
  

  Reply