Leave a reply

3 comments
  • To setup your Arlo Vmb 3000 cameras kindly follow these steps:-
    1.For the best experience, download the Arlo app for your smartphone by scanning the QR code below or searching for “Arlo” in the app store.
    2.Connect the base station to your router
    3.Connect the AC adapter to your base station and plug it in.
    4.Turn the base station on by pressing the On-Off button.
    5.The power LED and Internet LED on the front of the base station turn green in about two minutes.
    6.Launch the app from your smartphone and click the New System Setup button. Follow the on-screen instructions.
    7. from a computer, visit https://arlo.netgear.com/ and follow the on-screen instructions.
    8.Insert batteries-Unlock the battery compartment by sliding and holding the latch. Slide the battery door back and lift it to open the compartment. Insert the batteries as shown and close the battery door.
    9.Bring the camera within one to three feet (30 to 100 centimeters) of the base station.
    10.Press the Sync button on the side of the base station.Wait for the sync status LED to blink green.
    11.Press the Sync button on top of the camera. Cameras must be synced one at a time.
    12.A blue LED on the camera blinks rapidly to confirm sync. The camera is ready for viewing.
    13.The camera LED on the base station turns solid green after the camera is synced.
    For any help feel free to call us back on 1-800-603-4024.



    1



  • 1. Download the Arlo app
    2. Connect the base station to the router
    3. Make sure base station is connected to the adapter via wall socket and tuned on
    4. Launch the app and click new setup
    5. Bring the camera near the base station and press sync option
    6. Solid green/blue led will come on camera which means it is synced
    7. Follow the same steps if you have more than one camera
    8. Once done place the camera where ever you want too and start using them



    1



  • firstly u need to download arlo app
    then connect your base station with adopter and make shure it is plug in
    after that
    now connect your base station to router
    now go to the arlo app that you have downloded and click on new setup
    after that make sure the distance between your basestation and camera is less then a feetand press synk option it
    after you synk you see light starts blinking on your device and it gets to solid .
    if it gets solid blue or green you get sucess fully connected
    if light continue blinking try these same steps again
    after sucessfully connected you can place it where you want



    1



Written by Phil McLaren
Router Categories