Leave a reply

  • Use the end of a paper clip or a similar object to press and hold the Reset button on the back of the router for at least seven seconds. The router resets, and return to the factory configuration settings.

    Once it goes to the factory defaults then you can configure the router again and setup the wireless settings.


  • If you forgot the password simply reset your router with the help of paper clip by holding reset button for atleast 20-30 seconds and re setup the device.
    To setup your Netgear R6100 kindly follow these steps:-
    You need to plug in a cable from your existing modem to internet port of your router.
    after connecting this cable connect a cable from port no-4 of your router to your computer. then follow these steps:
    1. Press windows + R key that will open run window for you.
    2. Type CMD in the run box.
    3. Open Ipconfig and check network statistics.
    4. Open your default gateway in any browser.
    5. Type your user name and password .now it will be (username-admin, password-password)
    6. that will open a setup wizard for you so follow the steps while following the steps it will ask you
    to change admin credentials so set that as per your choice.
    7. while following the setup wizard kindly make sure the settings you are choosing is correct
    i.e time zone and wireless network name and key.
    8. kindly upgrade the router firmware as well if there is any update pending over there.
    For any help feel free to call us back on 1-800-603-4024.


Written by Anthony Bavaro
Router Categories