0
Susan Roberto-Saidi
...
0 Subscribers
Submit Answer
0 Answers
1.Log into the extender web-based management page
2.Configure WAN Connection Type. Change the WAN Connection Type to PPPoE.
3.Enter your PPPoE username and password which are provided by your ISP.
4.Click Save to save your settings, then the router will connect to Internet after a while.
5.Wait for a few minutes and check the WAN part on the Status page, if it shows any IP address (similar as below), that means the connection between the Router and the Modem is established.
6.If there is not wan IP address and no internet access, please do a Power Cycle.
Most DSL providers use Point-to-Point Protocol over Ethernet (PPPoE) to establish Internet connections for end-users. To set up tp-link-re305us router, you need to enable PPPoE on the router’s web-based setup page.
1. first connect your computer directly to your modem and check are you getting internet. If not,
contact your Internet Service Provider (ISP)
2. now connect the modem to the router’s Internet port and the computer to any of the four
Ethernet ports.
3. After connecting your modem and PC to the router, check the lights on the front panel of the
router.
4. now open the router main page on your computer.
5. now look for the Local IP Address and change it to 192.168.2.1 and save the settings.
6. Renew the computer’s IP Address.
7. Access the router’s web-based setup page using 192.168.2.1 as the IP Address.
8. On the Setup page, click Status and check if Internet IP Address has numbers or values.
9. Under the Setup tab, set the Internet Connection Type to PPPoE.
10.Enter the Username and Password that your ISP provided, including the domain in the User
Name field if necessary and save the settings.
by following these steps you can setup your router easily.
for any help feel free to call us back on 1-800-603-4024.