0
rapa1tech
I HAVE SET UP MY NEW TP LINK EXTENDE AND MY PRINTER IS NOT CONNECTING WITH NEW EXTENDER .....SO WHAT SHOULD I DO ?
0 Subscribers
Submit Answer
0 Answers
To setup your Cannon mg 3200 printer with your extender kindly follow these steps:-
Some access points feature an automatic connection button labelled “WPS” which stands for Wi-Fi Protected Setup.
This allows permitted devices such as your PIXMA MG3200 to connect to your network without needing to enter a password and it enables a quick and easy method of connecting your devices.
Before we start, there are some conditions that must be met in order to use the WPS push button method:
The access point must have a physical WPS push button available. Please check with your device’s user guide for details. Your network must be using the WPA (Wi-Fi Protected Access) or WPA2 security protocol. Most WPS enabled access points use this protocol.
1.Make sure that the printer is turned on.
If the power is on, the LED (Light Emitting Diode) must be lit on.
2. Press and hold the Maintenance button (A) on the printer for approximately 5 seconds.
3.Press the [Fit to Page] button
4. Make sure that the wps Led flashes , then press the [WPS] button on your access point within 2 minutes.
5.The (blue) Wi-Fi lamp on the printer will flash while searching for, or connecting to the access point.
6.When wireless connection is complete, the LED lights up for about 3 seconds, then changes to “1” Make sure that the (blue) Wi-Fi lamp on the printer is also lit.
For any help feel free to call us back on 1-800-603-4024.
If your router does not have a WPS button, please use the CD to perform the standard installation. Insert the disk into your computer and follow the prompts to perform the wireless installation from the computer.