0
David Fukumoto
Linksys wrt 3200 acm
0 Subscribers
Submit Answer
0 Answers
To reset your Linksys wrt 3200 acm router there are two ways :-
Method 1- Grab a paper clip and look for the reset button which you can find either underneath your router or at the rear panel. now you need to press the reset button with paper clip for
almost 7-10 seconds while its plugged in to a wall socket. when you will press reset button you
will notice change in pattern of lights blinking on the front. all lights will be off for a while except
power light.
2. On your computer, launch a web browser. In the address field of your browser, enter
your default gateway(192.18.1.1 -default) leave user name blank and type password for password If you have not yet personalized your password.now Click the Administration tab then click on the Factory Defaults sub-tab.now Under the Factory Defaults section, click on the Restore Factory Defaults button.your router is successfully reseted now.
By using above mentioned steps you can reset your extender. you need to use only one method either method 1 or method 2. for any help feel free to call us back on 1-800-603-4024.
Steps to reset your router-
1.Remove all the ethernet cables from your router .
2.Using a paper clip or a pin press and hold the reset button for 30 seconds.
3.Then release it and wait for 1-2 minutes.
4.Plug all the ethernet cables back in.Take another cable and plug it from router to your computer.
5.Open your browser and type in the address bar http://linksyssmartwifi.net and hit enter.
6.Setup wizard will appear follow the steps to configure your router .
To reset your your linksys router you need to remove all the cables from back of your router except the power one .
Now took a paper clip and insert it in the reset hole for 15 seconds and wait till the lights on your router starts blinking.
While holding down the clip you need to unplug your router from wall socket .
Now wait for 10 secs and remove the paper clip out from it.
Plug back your router again and wait for 2 minutes
You router is reseted now .
1. Use a paper clip
2. Devices do have a reset button which can be used to reset the device
3. You can also login into the router interface page and reset the settings to factory defaults