Leave a reply

1 comment
  • To connect your netgear dm 200 modem to a DSL service kindly follow these steps:-
    1. Install an ADSL or DSL microfilter between the phone line and the phone.
    The product package contains either an ADSL or DSL microfilter.
    2. Use a phone cable to connect the microfilter to the gray DSL port on the modem.
    The product package contains a phone cable.
    3. Connect the power adapter to the modem and plug it into an electrical outlet.
    Wait for the Power LED to light solid green, which takes about one minute.
    4. If the Power LED does not light, press the Power On/Off button.
    5. Check the DSL LED . If the modem is connected to a DSL service, the DSL LED lights green.
    6. Use an Ethernet cable to connect your computer to the yellow Ethernet LAN port on the modem.
    The product package contains a yellow Ethernet cable.Your computer connects to the modem’s LAN.
    7. Launch a web browser. In the address field of the web browser, enter http://www.routerlogin.net.
    When prompted, enter admin for the user name and password for the password.
    8. that will open a setup wizard for you so follow the steps and you are good to go.
    9. while following the setup wizard kindly make sure the settings you are choosing is correct
    i.e time zone and wireless network name and key.
    10. kindly upgrade the router firmware as well if there is any update pending over there.
    if problem still persists you can reset your router and follow the same steps.
    For any help feel free to call us back on 1-800-603-4024.



    0



Written by Timothy Rupard
Router Categories