Leave a reply

4 comments
  • Connect ethernet cable frrom broadband to your new router on internet port.
    :-Connect your computer with router.
    :-Open any internet browser type 192.168.1.1.
    :-Loginto router page
    :-Follow the instructions.
    :-Once router is setup
    :-Connect your devices with wifi.
    :-For additional help call call us at 1-800-603-4024..

  • Most DSL providers use Point-to-Point Protocol over Ethernet (PPPoE) to establish Internet connections for end-users. To set up Linksys EA 6700 router, you need to enable PPPoE on the router’s web-based setup page.
    1. first connect your computer directly to your modem and check are you getting internet. If not,
    contact your Internet Service Provider (ISP)
    2. now connect the modem to the router’s Internet port and the computer to any of the four
    Ethernet ports.
    3. After connecting your modem and PC to the router, check the lights on the front panel of the
    router.
    4. now open the router main page on your computer.
    5. now look for the Local IP Address and change it to 192.168.2.1 and save the settings.
    6. Renew the computer’s IP Address.
    7. Access the router’s web-based setup page using 192.168.2.1 as the IP Address.
    8. On the Setup page, click Status and check if Internet IP Address has numbers or values.
    9. Under the Setup tab, set the Internet Connection Type to PPPoE.
    10.Enter the Username and Password that your ISP provided, including the domain in the User
    Name field if necessary and save the settings.
    by following these steps you can setup your router easily.
    for any help feel free to call us back on 1-800-603-4024.

  • 1.Once you have your computer connected on the router.
    2.Open router page and select setup.
    3.In that list select ppoe connection and select next.
    4.Now you have to type in your login and password provided by ISP.
    5.Once that is done start using internet.
    6.If you still face any issues call us at 1-800-603-4024

  • Check the attachment for cable connection with your device-
    1.Once you connect your device simply boot your router.Make sure you are using wall socket.
    2.On your computer open your browser and type http://linksyssmartwifi.com or check the router IP by opening Command prompt and type IPCONFIG .Check the default gateway and use that IP in your browser in case smart wifi website doesn’t work.
    3.Setup wizard will appear and follow the steps to complete the configuration .
    4.Once your connected you can remove the cable from the computer and router .
    5.Now on your device got to wireless setting and look for your wireless name and connect to it .

Written by Bill
Router Categories