0
georgelewis
I WOULD LIKE TO KNOW HOW ย DO I SET UP MY EXTENDER FROM NETGEAR R 7000 ROUTER
0 Subscribers
Submit Answer
0 Answers
TO SETUP YOUR POWER LINE ADAPTER PL 1000 YOU NEED TO FOLLOW THESE STEPS:-
1. Plug PL 1000 adapter into a power outlet near your router.
2. Use the supplied gray Ethernet cable to connect from the PL 1000 adapter to a LAN port
on your router so that the Power line network can gain access to the Internet. The Power
and Ethernet LEDs on the Power line adapter should turn on.
3. you need to wait for at least 1 minute here and after that you can check the lights on your
adapter i.e power light , ethernet light , power line light.
There is a different way as well (by wps method)
Use WPS to Connect to Your Network
To automatically connect to the PowerLINE access point using a WPS button:
1. Press and hold the WPS button on the PowerLINE access point for
two seconds and release it. The WiFi LED starts to blink.
2. Press the WPS button on your WiFi device for two seconds and
release it.
When the WiFi LED stops blinking, your WiFi device is automatically
connected to the Power LINE access point and you can surf the web.
later on you can set security and customize the settings of your device as well .
if problem still persists you can reset your device and re setup the device.
To setup your powerline you need to follow these steps-
1.Plug you powerline adapter near to your router and connect it to your router using a ethernet cable .From LAN port to powerline.
2.Then plug your powerline extender in the wall where you need it and connect it to your computer using ethernet cable.
3.Now simply open your browser and type http://mywifiext.net and enter it will give you login screen simply type admin for username and password for password.
4.Now you can setup your powerline .