Leave a reply

2 comments
  • To setup your netgear router you need to follow these steps:-
    You need to plug in a cable from your existing modem to internet port of your router.
    after connecting this cable connect a cable from port no-4 of your router to your computer. then follow these steps:
    1. Press windows + R key that will open run window for you.
    2. Type CMD in the run box.
    3. Open Ipconfig and check network statistics.
    4. Open your default gateway in any browser.
    5. Type your user name and password .
    6. that will open a setup wizard for you so follow the steps and you are good to go.
    7. while following the setup wizard kindly make sure the settings you are choosing is correct
    i.e time zone and wireless network name and key.
    8. kindly upgrade the router firmware as well if there is any update pending over there.
    your router setup is complete now.

    For parental control you need to follow these steps:-
    To setup parental controls of router you need to follow these steps:-
    first you need to make sure that your device should be connected to the above mentioned router.then follow these steps:-
    1. Press windows + R key that will open run window for you.
    2. Type CMD in the run box.
    3. Open Ipconfig and check network statistics.
    4. Open your default gateway in any browser.
    5. Type your user name and password .
    6. now you are on router main page with all settings options.
    7. now Go to Advanced->Parental Control and enable Parental Controls. Then please set you
    parental PC, you can set Mac address of parental PC manually, or you can Click Copy To Above,
    set the computer you used as parental PC. Click Save.
    8. Click reboot Icon to make the parental control function take effect. Reboot Icon at upper right
    hand side of the page.
    For any help feel free to call us back on 1-800-603-4024.



    0



  • Steps to configure router :-
    :-Connect one end of the yellow ethernet cable to your modem and the other end to the Internet port on your router.
    :-Plug in and turn on your modem.
    :-Connect your computer to the router .
    :-Open any internet browser
    :-If the webpage is not display close and reopen the browser then enter
    http://www.routerlogin.net
    :-Once setup wizard is open follow the nstruction
    :-Once its done router will save the settings.
    :-Now you can connect your devices with router.

    Parental control :-
    :-. Go to Advanced->Parental Control and enable Parental Controls. Then please set your
    parental PC, you can set Mac address of parental PC manually, or you can Click Copy To Above,
    set the computer you used as parental PC. Click Save.
    Click reboot Icon to make the parental control function take effect. Reboot Icon at upper right
    hand side of the page.

    :-If problem still persist call at 1-800-603-4024 and get additional help from expertise.



    0



Written by ferris
Router Categories