In order to add an additional Linksys Node with the Primary Node, we need to follow some steps which are shown below:-
Connect your computer with the Primary Node's wifi network
> Open a browser on your computer and type this address:- 192.168.1.1
> it will take you to login page of the Velop system
> and then enter your login information for your velop system and default password is "admin"(without quotes).
> Once you are logged in, then click on the CA link at the bottom right-hand corner of the screen
> Go to Connectivity > Velop Setup and set the SSID and Password of your Velop network. Then, click the Setup Node button to proceed.
To add an additional node, Turn it On and wait until you have a solid purple light. Once you have a solid purple light on the additional node, proceed to the next step
> connect an ethernet cable between the primary node and additional node.
> After a minute, the light indicator will start blinking purple. When the light indicator on the additional node turns solid blue, this means your additional node is ready. You can now disconnect the additional node from the Primary node and place it at the desired location
> If you are done adding nodes, click on Done Adding Nodes