Router set up Linksys

2 comments

• TO SET UP YOUR LINKSYS ROUTER YOU NEED TO FOLLOW THESE STEPS:
  1. PLUG IN YOUR ROUTER TO A WALL SOCKET.
  2. CONNECT AN ETHERNET CABLE FROM YOUR MODEM TO INTERNET PORT OF YOUR ROUTER.
  3. CONNECT ANOTHER ETHERNET CABLE FROM PORT NO-4 OF YOUR ROUTER TO YOUR COMPUTER.
  4. OPEN RUN WINDOW AND TYPE CMD FOR ACCESSING LINKSYS ROUTER WRT54G V8.2.
  5. THEN ON CMD WINDOW TYPE IPCONFIG IT WILL SHOW YOU NETWORK STATISTICS.
  6. THEN OPEN A BROWSER AND TYPE DEFAULT GATEWAY IN ADDRESS BAR HIT ENTERS.
  7. WHEN YOU WILL HIT ENTER KEY THERE WILL BE A PROMPT ASKING USERNAME AND PASSWORD.
  8. DEFAULT USERNAME-admin PASSWORD-password.
  9. IT WILL OPEN A SETUP WIZARD YOU JUST NEED TO FOLLOW STEPS AND LINKSYS E1200 ROUTER WILL BE CONNECTED TO NETWORK.
  IF STILL PROBLEM PERSISTS YOU CAN RESET YOUR DEVICE.
  FEEL FREE TO CALL US BACK ON 1-800-603-4024.

  Reply

• Steps you need to follow-

  1.Make sure if there is any firmware update just do that.
  2.Change the channel to 11 for 2.4ghz network.
  3.Also check if the router is connected to wall socket only.No surge protector or extension.
  4.Try resetting the router and then try connecting your devices .

  Still getting problem call our toll free 1-800-603-4024.
  We have best technicians for router.

  Reply