0
poorfarmer1
how to set up N300 extender
0 Subscribers
Submit Answer
0 Answers
TO CONNECT YOUR NETGEAR N 300 EXTENDER YOU NEED TO FOLLOW THESE STEPS
1. CONNECT YOUR EXTENDER IN A DIRECT WALL SOCKET.
2. PRESS WPS BUTTON ON YOUR EXTENDER FOR 3-5 SECONDS.
3.PRESS WPS BUTTON ON YOUR ROUTER (YOU CAN DO IT BY ACCESSING ROUTER MAIN PAGE ALSO).
4.IT WILL BE CONNECTED TO YOUR ROUTERS NETWORK.
5.YOU WILL SE YOUR NETWORK NAME WITH EXT AFFIXED IN IT.
6.CONNECT TO THE SAME NETWORK .
7. IT WILL OPEN A SETUP WIZARD FOR YOU.
8.FOLLOW THE STEPS OF WIZARD AND YOU ARE GOOD TO GO NOW.
(IF PROBLEM STILL PERSISTS YOU CAN RESET YOUR DEVICE.)
FOR ANY QUESTION & QUERY FEEL FREE TO CALL US ON 1-800-603-4024.
Setting your Netgear WN300RPv3 Range extender.
1.Plug your extender in the wall .
2.Connect a Ethernet cable from extender to your computer.
3.Once your connected open your browser and type 192.168.1.250 / 192.168.1.254 .
4.Setup wizard will appear .
5.Create an account first.
6.Select range extender as your mode .
7.Follow the steps to complete the setup.
8.When setup is complete simply disconnect the ethernet cable from extender and computer .
Setting up netgear n300 extender is really easy using WPS button. Here are the steps you will need to follow,
•First you will need to place the Netgear extender near to your router and then plug in the power to WiFi extender.
•Press the WPS button located at the Netgear extender and then press the wps button on your router, within two minutes, netgear extender will connect itself with the existing network.
•You will notice that the LED status will be stable green.
Once your Netgear extender is connected with the existing network you can place the WiFi extender for the dead zones you are facing at your location.