how to configure my belkin n300?
> Turn On your Belkin Router
> Connect your router with the modem using an ethernet cable(make sure cable is connected to the internet slot)
> Now connect your computer with the router's network or you can also connect an ethernet cable between router and computer.
> then open your browser and type this address:- 192.168.2.1
> After that follow the instructions and complete the router setup
> once the router is complete ,after that you can connect your devices with the router's network.
Mostly belkin extenders are plug & play devices.
Steps you need to follow to configure your N300 :
1. Make sure your plugged in properly.
2. When it shows blue & amber light that means its ready to configure.
3. Do check it shows on your wifi list there.
4. Connect to it.
5. Once connected open any web browser which will redirect you to the setup page if not type in there - 192.168.206.1 ( EXT IP).
6. Now just follow simple guided steps.
7. You good to go.
Mostly belkin extenders are plug & play devices.
Steps you need to follow to configure your N300 :
1. Make sure your plugged in properly.
2. When it shows blue & amber light that means its ready to configure.
3. Do check it shows on your wifi list there.
4. Connect to it.
5. Once connected open any web browser which will redirect you to the setup page if not type in there – 192.168.206.1 ( EXT IP).
6. Now just follow simple guided steps.
7. You good to go.
> Turn On your Belkin Router
> Connect your router with the modem using an ethernet cable(make sure cable is connected to the internet slot)
> Now connect your computer with the router's network or you can also connect an ethernet cable between router and computer.
> then open your browser and type this address:- 192.168.2.1
> After that follow the instructions and complete the router setup
> once the router is complete ,after that you can connect your devices with the router's network.