0
Brady Castille
Not ABle To Connect Sr10000 with Netgear
0 Subscribers
Submit Answer
1 Answers
Best Answer
0
Plugin the extender into the wall socket and make sure it is in the at least 5 feet range from the main router for the initial setup. now press and hold the WPS button on the router for 5 seconds and then within the 1-minute press and hold the WPS button on the extender for 3 seconds and now with the help of any laptop or computer connect to the extender wifi and then open the browser.in the long address bar of your browser type the IP address of the extender and it will open the login dashboard, fill in the login details once you are logged setup the security password and save the settings.
Replying as
Submit
In order to set up an amped extender SR10000 With a Netgear Router, Please follow the Instructions below:
> > Plug in the Extender to a wall outlet directly
> Connect your computer to the wifi of your extender to the default SSID or the network name
> Pull up a browser and at the top type in 192.168.1.240
> you will see a scan button click on that
> look for your existing network select that enter the password
> click on next it will take at least 2 -3 minutes to complete the setup once its done it will ask you to connect your devices to the extended network.
> Setup is Complete
Report Reply
To set up an amped extender SR10000 With a Netgear Router, Please follow the Instructions below:
1) Plug in the Extender to a wall outlet directly.
2)Connect your computer to the wifi or with the ethernet cable of your extender.
3) Pull up a browser and type 192.168.1.240
4) you will see a scan button click on that.
5) look for your existing network select that enter the password.
6) click on next it will take at least 2 -3 minutes to complete the setup once its done it will ask you to connect your devices to the extended network.
7) Setup is Complete.
To setup amped SR10000 range extender follow these steps:-
>Plugin the amped range extender near to your home router for the initial setup.
*If you made any change on the extender before, then reset the extender by pressing reset button for at least 20 seconds.
>Connect any of your wireless device with amped wireless network.
>Open any browser and in the address bar type 192.168.1.240 or http://setup.ampedwireless.com
>Now you will see the SCAN button on the page, click on it and after that it will scan the wireless networks nearby to it.
>From the list select network that you want to extend and then enter password for the same.
>In the next step if you want you can change the name of extended network and password of your choice that you want for it.
>Now save the settings and range extender will reboot after saving the settings.
>Once extender lights get solid connect your devices to the extended network and try to go online so that we can check that extender setup done successfully.
#To setup your AMPED SR10000 extender kindly follow these steps:-
-Plug in your extender in to the wall socket
-Press the reset button/Pin hole on your extender for 10 seconds .
-Wait Till the time all lights on you extender are back again.
-Now you can connect your computer with the extended network.
-Once connected with network open the Default IP of your extender i.e 192.168.1.240 or http://setup.ampedwireless.com
-Now follow the steps and set up your extender with the existing network
-Once configured You can took your extender to the place where you would like to use it
-Connect your devices with the extended network .
-Still facing any issues you can call us at 1800-810-8012 and ask for help.