How to setup Belkin Extender?

2 comments

• For new Belkin N300 Extender.
  Just press the WPS on your router/modem first for 1-2 seconds, then press the WPS on Belkin N300 Extender for 3-5 seconds.
  Now wait for 2 minutes.
  The Change in light color and pattern will confirm its connection.

  For Used/ Old Belkin N300 Extender: If its an used Belkin N300 Extender then first reset it using a paper clip to press the reset button in a tiny hole for 30 seconds. Wait for 2 minutes.
  Now its brand new, or by default one.
  Wait for 2 minutes after reset then proceed further as setup New Extender.

  Its now Extending your home network with same password as of your home WiFi.

  Note:
  1. During setup, make sure that the Belkin N300 Extender is placed within 7-10 feet from Router at the time of setup, or in the same room.
  2. Two minutes patience is the Critical Time that make the difference between success and failure in Setup.
  3. Best of luck

  Reply

• In order to configure the Belkin range extender you need to follow the instructions below:
  > plug in your extender near to the router for the initial setup atleast 10 feets
  > Press the WPS button on the router for 3 -4 seconds and then on the Extender for 3- 4 Seconds
  > Once you see the light stops flashing on the extender it means the extender is setup now
  Step 2
  > Connect your computer wireless to the extended network
  > pull up browser and at the very top type in 192.168.2.1
  > You will get through a login window default username: admin and the Password : admin
  > click on quick setup and Continue , Follow the instructions to complete the setup

  Reply