How to set up Netgear R7000

2 comments

• In order to setup your R7000 Netgear router please follow the following steps?
  > Connect a Ethernet cable from Modem’s LAN port to the router into the internet port.
  > Connect your computer Wireless or via ethernet to the router.
  > Pull up a browser and at the top on the address bar type http://www.routerlogin.net or 192.168.1.1 and hit enter button on the keyboard.
  > You will see a Netgear setup wizard all you need to do is follow the instruction and complete the setup.
  > you can change the name and the password aswell.

  Reply

• To setup your Netgear R7000 router you need to follow these steps:-
  You need to plug in a cable from your existing modem to internet port of your router.
  after connecting this cable connect a cable from port no-4 of your router to your computer. then follow these steps:
  1. Press windows + R key that will open run window for you.
  2. Type CMD in the run box.
  3. Open Ipconfig and check network statistics.
  4. Open your default gateway in any browser.
  5. Type your user name and password .
  6. that will open a setup wizard for you so follow the steps and you are good to go.
  7. while following the setup wizard kindly make sure the settings you are choosing is correct
  i.e time zone and wireless network name and key.
  8. kindly upgrade the router firmware as well if there is any update pending over there.
  if problem still persists you can reset your router and follow the same steps.
  For any help feel free to call us back on 1-800-603-4024.

  Reply