Amped APA20

2 comments

• 1.Attach the Antennas to their Specific Connectors on the Access Point
  2.Plug in the Power Adapter.
  3.Connect the Access Point to your Router’s Network (LAN) port, or a network switch.
  4.Allow up to three (3) minutes for the Access Point to automatically configure itself to your network.
  5.Scan for available wireless networks on your PC or tablet and connect to one of the following networks: Amped_APA20_2.4 or Amped_APA20_5.0 password for both networks are password.
  6. you are good to now .
  7. to check web utility kindly ping http://setup.ampedwireless.com on any browser.
  8. from there you can manage settings of your device.
  for any help feel free to call us back on 1-800-603-4024.

  Reply

• Attach the three included Antennas to
  their corresponding numbers:
  Antenna 1 (5.0GHz only) to Antenna Port 1
  Antenna 2 (2.4 and 5.0GHz) to Antenna Port 2
  Antenna 3 (2.4GHz only) to Antenna Port 3

  Plug in the Power Adapter
  Connect the Access Point to your Router’s Network (LAN) port, or a network switch.
  Allow up to three (3) minutes for the Access Point to automatically configure itself to your network.
  Attach any Wired Devices to the Access Point using an Ethernet cable.

  For wireless connections
  Scan for available wireless networks on your PC or tablet and connect to one of the following networks:

  Network name :- Amped_APA20_2.4 and Amped_APA20_5.0
  Password :- wireless

  If you still unable to configure your Access Point than feel free to call us at 1-800-603-4024.

  Reply