0
DAVID WAKIN
BELKIN F9K11V9
0 Subscribers
Submit Answer
0 Answers
Start by connecting directly to the router through an Ethernet cable.
Connect via Ethernet to Troubleshoot.
Locate the Ethernet jack on the rear of your Belkin router.
Reset Windows TCP/IP Settings.
Click the “Start” button.
Check Wi-Fi Security Settings.
Check Wireless Broadcast Settings.
Reset the Router.
If problem still persist call us at 1-800-603-4024
1.Begin by clicking Windows Logo > Control Panel.
2.Click Network and Internet.
3.Click on Network & Sharing Center.
4.Click the name of the connection you wish the edit, to the right of Connections.
5.Click Properties.
6.Select Internet Protocol Version 4 (TCP/IPv4) and click Properties.
7.Click the radio button next to Use the following DNS server addresses:. This will allow you to enter the DNS server addresses.
8.The DNS addresses are as follows:
Preferred DNS server: 8.8.8.8
Alternate DNS server: 8.8.4.4
9.Click OK on each of the windows and close the Control Panel. Your computer is now configured to use statically assigned DNS server addresses.
To setup your Belkin router you need to follow these steps:-
You need to plug in a cable from your existing modem to internet port of your router.
after connecting this cable connect a cable from port no-4 of your router to your computer. then follow these steps:
1. Press windows + R key that will open run window for you.
2. Type CMD in the run box.
3. Open Ipconfig and check network statistics.
4. Open your default gateway in any browser.
5. Type your user name and password .
6. that will open a setup wizard for you so follow the steps and you are good to go.
7. while following the setup wizard kindly make sure the settings you are choosing is correct
i.e time zone and wireless network name and key.
8. kindly upgrade the router firmware as well if there is any update pending over there.
if problem still persists you can reset your router and follow the same steps.
For any help feel free to call us back on 1-800-603-4024.