0
jeffery
ARCHER C 2600
0 Subscribers
Submit Answer
0 Answers
As you have mentioned that feature of port forwarding is not working on your Tp link archer c 2600 router is not working In this case kindly reset your router with the help of a paper clip to factory default settings and re setup your router.
To Re setup the device kindly follow these steps:-
You need to plug in a cable from your existing modem to internet port of your router.
after connecting this cable connect a cable from port no-4 of your router to your computer. then follow these steps:
1. Press windows + R key that will open run window for you.
2. Type CMD in the run box.
3. Open Ipconfig and check network statistics.
4. Open your default gateway in any browser.
5. Type your user name and password .
6. that will open a setup wizard for you so follow the steps and you are good to go.
7. while following the setup wizard kindly make sure the settings you are choosing is correct
i.e time zone and wireless network name and key.
8. kindly upgrade the router firmware as well if there is any update pending over there.
if problem still persists you can reset your router and follow the same steps.
For any help feel free to call us back on 1-800-603-4024.
1. Try rebooting your router and perform power cycle
2. If this doesn’t work then reset your router by using a paper clip for 30 seconds which will take your device to factory settings
3. Configure the settings again and choose the right options to setup port forwarding
4. Save the settings and you are good to go
Follow the steps below for troubleshooting on port forwarding failures on a Tp-link router.
Make sure the server is accessible from internal network.
Check if you can access that server in the local network. If you are unable to access the server in your local network, please check settings of your server.
Check the port forwarding settings in the router.
Log into the router, then go to the port forwarding section; forwarding>virtual server.
Pay attention to the WAN IP address in status page.
If there are still problems, please check the WAN IP of the router. Verify the router is getting a public IP address. If it is a private IP address, which means it’s not enough to only open port on the TP-Link, you have to do the same setting on the modem router as well.
Feel free to contact us at 1800-603-4024 if it still not working.
Check these things –
-Make sure all the values you are putting are correct for the correct device.
-Don’t try port forwarding on the router’s IP .
-Disconnect all the cables from the router and power cycle your router and modem.
-Wait for 2-3 minutes.Turn on the devices.
-If it doesn’t work reset the router and try again.