0
john roche
i have changed my router recently and now i am looking to reconfigure the belkin extender .....but donot know how to do that?
0 Subscribers
Submit Answer
0 Answers
There are several ways to configure your Belkin extender i.e ethernet cable method ,wps method and many more but i am sharing wps method here for wps method you need to follow these steps:-
1. connect your extender in a direct wall socket near by your router for setup.
2. press wps button on your extender for 3-5 seconds.
3. press wps button on your router (you can do it by accessing router main page also).
4. it will be connected to your routers network.
5. you will see your network name with ext affixed in it.
6. connect to the same network .
7. it will open a setup wizard for you.
8. follow the on screen instructions and you are good to go now.
(if problem still persists you can reset your device.)
for any question & query feel free to call us on 1-800-603-4024
To reconfigure your extender first we need to reset it
Plug in your extender into wall socket
When power light turns solid
Look at the back of your extender there would be a little reset button
Use a paper clip or any sharp object
Press and hold it down for ten seconds when you see power light starts blinking you can release the clip
Wait your extender will reboot when you see power light turns solid.
Connect your computer with extender hard wired or wirelessly
Launch any internet browser using interface http://www.belkin.range or type ip address 192.168.206.1 and hit enter
For more assistance call us at 1-800-603-4024
1. Plug the extender to wall outlet.
2.Power light should lit up as solid green or blue.
3.Connect the extender with wire to the computer.
4.Launch http://www.tplinkrepeater.net
5. It will show the extender page, start setting up the extender and you can choose the existing wireless network settings to configure your extender.
6. Once done you can start connecting your devices to the extender and they will work fine.
Use a pin or paperclip and press the “Reset” button.
press and hold the “Reset” button down for 30 seconds.
Wait for one minute for your Router to fully Reboot and restore the factory setting.
Once Both Devices Are rebooted You Can See a Network By The Name Of Belkin.setup Please Connect With it.
Now Open Your Browser And It Will Automatically Take yours to Belkin setup page if not enter 192.168.2.1
Follow The Instruction And Select Your Wireless Network Name And Type The Password And Hit Next.
Your Router Is Configured