0
Hervery Young
.....
0 Subscribers
Submit Answer
0 Answers
To setup your Linksys Ea6400 router you need to follow these steps:-
You need to plug in a cable from your existing modem to internet port of your router.
after connecting this cable connect a cable from port no-4 of your router to your computer. then follow these steps:
1. Press windows + R key that will open run window for you.
2. Type CMD in the run box.
3. Open Ipconfig and check network statistics.
4. Open your default gateway in any browser(192.168.1.1 is default gateway in general).
5. Leave your user name blank and type admin in password box.
6. that will open a setup wizard for you so follow the steps and you are good to go.
7. while following the setup wizard kindly make sure the settings you are choosing is correct
i.e time zone and wireless network name and key.
8. kindly upgrade the router firmware as well if there is any update pending over there.
if problem still persists you can reset your router and follow the same steps.
For any help feel free to call us back on 1-800-603-4024.
To install your router:-
1. Power on your new router.
2. Connect the Internet cable from your modem to the yellow Internet port
on your router. Wait until the power light on the front of the router is
solid.
3.Connect your computer to router
4. Open a web browser and follow the instructions to complete your
router’s setup. If instructions do not appear in the web browser, enter
linksyssmartwifi.com in the browser’s address bar.
5. Follow the instructions and complete the setup.
For additional help call us at 1-800-603-4024
Check the attachment for cable connection with your device-
1.Once you connect your device simply boot your router.Make sure you are using wall socket.
2.On your computer open your browser and type http://linksyssmartwifi.com or check the router IP by opening Command prompt and type IPCONFIG .Check the default gateway and use that IP in your browser in case smart wifi website doesn’t work.
3.Setup wizard will appear and follow the steps to complete the configuration .
4.Once you are connected you can remove the cable from the computer and router .
1.Open your browser and open http://linksyssmartwifi.com
2.Setup screen will appear
3.Start the setup and follow the onscreen instructions’
4.Choose a Wifi name and password
5.Upgrade the firmware if available
6.Save settings