0
Andre Picado
........
0 Subscribers
Submit Answer
0 Answers
TO SETUP YOUR POWER LINE ADAPTER PLW 1010 YOU NEED TO FOLLOW THESE STEPS:-
1. Plug PLW 1010 adapter into a power outlet near your router.
2. Use the supplied gray Ethernet cable to connect from the PLW 1010 adapter to a LAN port
on your router so that the Power line network can gain access to the Internet. The Power
and Ethernet LEDs on the Power line adapter should turn on.
3. you need to wait for at least 1 minute here and after that you can check the lights on your
adapter i.e power light , ethernet light , power line light.
There is a different way as well (by wps method),Use WPS to Connect to Your Network
To automatically connect to the PowerLINE access point using a WPS button:
1. Press and hold the WPS button on the PowerLINE access point for
two seconds and release it. The WiFi LED starts to blink.
2. Press the WPS button on your WiFi device for two seconds and
release it.
When the WiFi LED stops blinking, your WiFi device is automatically
connected to the Power LINE access point and you can surf the web.
later on you can set security and customize the settings of your device as well .
if problem still persists you can reset your device and re setup the device.
For any help feel free to call us back on 1-800-603-4024.
Plug in your new adapters
Wait until the Pick A Plug LEDs are lit
Connect your computer with new extender
Launch any internet browser using interface http://www.mywifiext.net
Go through with the setup
Once its done.
Connect your devices with extender and check you are getting internet.
For additional help call us at 1-800-603-4024..