0
RON
How do i configure my arlo camera with netgear router
0 Subscribers
Submit Answer
0 Answers
To set up and sync Arlo Wire-Free cameras with your netgear router you need to follow these steps:-
1. Connect the base station to your router using an Ethernet cable.
2. Connect the AC adapter to your base station and plug it in.
3. The Power LED and Internet LED on the front of the base station light green in about two
minutes.
4. Open a browser, visit https://arlo.netgear.com/ and follow the onscreen instructions.
5. unlock the battery compartment by sliding and holding the latch.
6. Slide the battery door back and lift it to open the compartment.
7. Insert the batteries as shown and close the battery door.
8. Bring the camera within one to three feet of the base station.
9. Sync the camera to the base station.
10.press the Sync button on the side of the base station for about two seconds and then release
the button.
11.Wait for the sync status LED to blink green.
12.Press the Sync button on top of the camera for about two seconds and then release the button.
13.A blue LED on the camera blinks rapidly to confirm sync.
Check the camera LED on the base station. If the camera LED on the base station turns solid green, the sync process is complete. Repeat these steps for each camera.
if problem still persists feel free to call us back on 1-800-603-4024.
follow these steps to setup your arlo camera.
1.CONNECT YOUR BASE STATION WITH AN ETHERNET CABLE WITH YOUR ROUTER.
2.THEN OPEN http://WWW.ARLO.NETGEAR.COM AND CLICK ON NEW SETUP.
3.IT WILL DETECT YOUR BASE STATION AND THEN YOU NEED TO MAKE AN ACCOUNT WITH ARLO.
4.LAST STEP IS TO SYNC ARLO CAMERA WITH YOUR BASE STATION.
5.IF YOU ARE STILL FACING ISSUES,PLEASE CALL US AT Toll Free-1-800-603-4024
Setup for arlo camera –
1.Connect your base station with router with the help of an ethernet cable.
2.Open your browser and type http://arlo.netgear.com .
3.Hit New to Arlo.
4.Select the base station from the list.
5.Once it detects the base station create your account.
6.Start with camera setup now.
7.Press and hold the sync button on basestation for two seconds then release it.Green LED will blink.
8.Now press and hold the sync button on the camera for two seconds then release it.
9.Blue LED will blink on the camera.When it gets rapid it means camera is setup.
10.Do the same with other cameras one by one .