Leave a reply

4 comments
  • TO ACCESS YOUR EXTENDER MAIN PAGE YOU NEED TO CHECK IP ADDRESS OF YOUR EXTENDER ON ROUTERS MAIN PAGE AND YOU NEED TO OPEN THE SAME IP ADDRESS ON A BROWSER AND TRY TO OPEN IT WITH DEFAULT PASSWORD IF IT WORKS THEN GOOD OTHERWISE YOU NEED TO RESET AND RE SETUP YOUR EXTENDER FOR RE SETUP YOU NEED TO FOLLOW THESE STEPS:-

    1. CONNECT YOUR EXTENDER IN A DIRECT WALL SOCKET.
    2. PRESS WPS BUTTON ON YOUR EXTENDER FOR 3-5 SECONDS.
    3. PRESS WPS BUTTON ON YOUR ROUTER (YOU CAN DO IT BY ACCESSING ROUTER MAIN PAGE ALSO).
    4. IT WILL BE CONNECTED TO YOUR ROUTERS NETWORK.
    5. YOU WILL SEE YOUR NETWORK NAME WITH EXT AFFIXED IN IT.
    6. CONNECT TO THE SAME NETWORK .
    7. IT WILL OPEN A SETUP WIZARD FOR YOU.
    8. FOLLOW THE STEPS OF WIZARD AND YOU ARE GOOD TO GO NOW.
    FOR ANY HELP FEEL FREE TO CALL US BACK ON 1-800-403-6024.



    0



  • Sometimes login into tplnk extender through website does not work .So for that you need to follow these steps-

    1.First login into your host network page.
    2.Once you are in your router page check connected devices.
    3.You will find RE305 in the list.
    4.Check the IP address and just use that in the browser .
    5.Login screen will appear just use default login .(admin for both)

    Still not working try resetting it and setup it again .



    0



  • TRY RESETING THE EXTENDERS AND THEN

    •First you will need to place the tp-link extender near to your router and then plug the power to WiFi extender.
    •Press the WPS button located at the tp-link extender and do the same on your router, within two minutes, tp-link extender will connect itself with the existing network.
    •Type http://tplinkrepeater.net or 192.168.0.250 in address bar ,if the setup is not working.
    •You will notice that the LED status will be solid green,it means its ready to use.

    NOTE:-
    Once your tp-link extender is connected with the existing network you can place the WiFi extender where the dead zones are at your location.



    0



  • > login into the router settings of your router
    > Go to the DHCp Client table or , Wireless Client table, attached devices
    > you will see the model number of your extender in the list
    > Copy the assigned IP address of the extender, pull up a browser put the Ip on the address bar on the top and hit enter , you should be able to see the extender login screen

    Note if this is not working ether, Reset the extender and set up again.



    0



Written by susanalt
Router Categories